Kickplate; Outer Door Panel; Console; Electronic Control - Frigidaire FDB2410HIB Servicing

Section 4 Component Teardown
Kickplate Removal
Remove the kickplate by extracting the two screws
securing the kickplate to the front cross brace.
(See Figure 4-1)
Outer Door Panel Removal
1. Disconnect power from unit.
2. Fully open door.
3. The outer door panel and console are secured with
screws to the inner door assembly. (See Figure 4-2)
The screws labeled "A" in Figure 4-1 pass through
the console then fasten into the outer door panel.
While holding outer door panel in place, extract the
four screws from both sides of inner door panel.
4. Continue holding outer door panel in place as you
close the door. Slide the outer panel down until free
of the console. Remove outer panel from unit.
Console Removal
1. Disconnect power to the dishwasher.
2. Remove outer door panel.
3. Extract the four remaining screws holding the
console to the inner door panel. It is recommended
to remove the center two screws last, this helps to
hold console to prevent damage to wire harness.
(See Figure 4-2)
Electronic Control Removal
1. Disconnect power to the dishwasher.
2. Remove outer door panel.
3. Remove the console.
4. Extract the four screws securing control cover to
console. (See Figure 4-3)
5. Remove wires and disconnect plugs from control.
Some of the disconnect plugs may be glued on,
carefully trim glue away from disconnect plugs. The
plugs will not need to be re-glued to new control.
6. Remove screws mounting control board to console.
(See Figure 4-4)
CAUTION
When handling or replacing a control board, it is
important the servicer have a wrist ground strap on
and connected to the cabinet or another ground to
prevent static electricity from damaging the board.
4-2
Mounting Screws
Figure 4-1.
Outer Door Panel Screws
A
Console Screws
Figure 4-2.
Cover Mounting Screws
Mounting Screws For Display Switch
Figure 4-3.
IMPORTANT
All terminals on this
dishwasher are locking
terminals and have a
release that needs to be
pressed down to remove
wires from all electrical
terminals.
A
Ribbon
Cable
Release
Tab