Install 90° Elbow; Position Water Line And House Wiring; Insert Drain Hose Through Cabinet - Frigidaire FDB2410HIB Servicing

Section 2 Installation Information
Install 90° Elbow
1. Wrap 90° elbow with thread seal tape.
2. Install a 90° elbow onto the water valve.
(See Figure 2-10)
3. Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
4. Position the end of the elbow to face the rear of the
dishwasher.

Position Water Line and House Wiring

Position water supply line and house wiring on the floor
of the installation opening to avoid interference with
base of dishwasher and components under dishwasher.
(See Figure 2-11)

Insert Drain Hose Through Cabinet

Insert drain hose into cabinet wall hole.
If a power cord is used, guide the end through a
separate hole. (See Figure 2-12)
NOTE
Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
2-8
90˚
Elbow
Thread
Seal Tape
Figure 2-10.
Water
House
Line Wiring
Figure 2-11.
Insulation
Blanket
Figure 2-12.
Fill
Hose
Water
Valve
Bracket
4"
6"
Maximum
Drain Hose
Length 10'
Water
Line
Drain
Hose
House
Wiring
Power Cord
(if used)