Table of Contents
Advertisement
Burn
Hazard
_
Allow heating element to cool before
cleaning the interior.
Failure to do so can result in burns.
Outside
= Occasionally, use a soft cloth
to wipe the outside with a mild nonabrasive
detergent and water. Then rinse and dry.
Inside
= The inside of the dishwasher,
including the filter, is self-cleaning
with normal
use. If needed, clean around the tub gasket
area with a damp cloth.
Heatinc Element
Spray Arm/Tower
Assembly
Filter
Overfill
Protector-
keeps
dishwasher
from overfilling and is located in the left front
corner of the tub.
Clean occasionally with household cleaner
containing vinegar or bleach to dissolve
any buildup.
Overfill Protector should move up and
down freely about one inch. If it does
not move, lift and clean underneath.
1
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so
the dishwasher will drain properly.
A drain
air gap is usually mounted on the countertop
and can be inspected by removing the cover.
This is not part of your dishwasher and is not
covered by warranty.
Hard
water may cause lime deposit buildup
on the interior of the dishwasher.
For
cleaning instructions see "Removing Spots
and film" section.
Property
Damage
Hazard
Freezing temperatures
may cause water
lines to rupture.
Be sure all supply lines to
and circulating
lines within dishwasher are
protected.
Failure to do so could result in property
damage.
See Installation
Instructions for more details
on disconnecting and restoring service to
your dishwasher.
Advertisement
Table of Contents
