Door Spring; Inner Door Panel; Hinge Assembly - Frigidaire FDB2410HIB Servicing

Section 4 Component Teardown
Door Spring Removal
NOTE
When removing the product from under the counter,
extreme care must be taken to protect the product and
the floor from damage. Always use protection under
feet and legs when pulling unit out. When reinstalling,
make sure product is leveled and secured.
1. Extract dishwasher installation screws and pull
forward to access door spring.
2. Pull pin out of side frame to release top of spring.
(See Figure 4-8)
3. Replace spring, adjust as needed by installing pin
into proper hole in frame. Apply grease on both
ends of the spring after making final adjustment.
4. Reinstall making sure unit is level and secure.
Inner Door Panel Removal
1. Disconnect power to the dishwasher.
2. Remove outer door panel and console.
3. Disconnect wire harness connections from door latch
and dispenser assembly terminals.
4. Cut retaining straps securing wire harness to inner
door panel. Pull wire harness through inner door
panel and hinge assembly. Extract the screw
securing the ground wire to the hinge assembly.
(See Figure 4-10)
5. Loosen dishwasher from its installation position and
pull forward to access door spring.
6. Pull pin out of side frame to release top of spring.
(See Figure 4-8)
7. Extract the four screws securing inner door panel
to hinge assembly. Remove inner door panel from
unit. (See Figure 4-9)
Hinge Assembly Removal
1. Remove inner door panel.
2. Remove the hinge pin clamp from each side of the
hinge assembly. (See Figure 4-10)
3. Pull the hinge pin out of hinge assembly. Hinge
assembly will drop from the unit.
4. Reassemble in reverse order making sure lubricant is
used on both ends of springs.
5. Adjust springs as needed before installing under
counter.
6. Reinstall making sure unit is level and secure.
4-4
Figure 4-8.
Figure 4-9.
Remove Hinge Clamp
(Both Sides)
Figure 4-10.
Pull Pin from Frame
Adjustment
Holes
Spring
Mount
Remove Screws From
Both Sides of Inner Door
Ground
Wire
Screw