Table of Contents
Advertisement
Installing an SFP+ transceiver
NOTE
Always use the pull tab to insert or remove transceivers as they might be hot.
1.
Perform one of the following steps, depending on your transceiver type.
•
If the transceiver uses a pull tab, use the pull tab to help push the transceiver into the port until it is firmly seated and the
latching mechanism clicks.
FIGURE 34 Installing an SFP+ transceiver with pull tab into the interface module port
•
If the transceiver uses a bail latch mechanism (10 GbE transceivers only), ensure that the bail (wire handle) is in the
unlocked position, grasp the transceiver, and push it into the port until firmly seated. Close the bail to latch the transceiver in
the slot.
64
1.
Pull tab
2.
Transceiver
ExtremeSwitching SLX 9540 Hardware Installation Guide
9036360-00 Rev AB
Advertisement
Table of Contents
Related Manuals for Extreme Networks ExtremeSwitching SLX 9540
Related Products for Extreme Networks ExtremeSwitching SLX 9540
- Extreme Networks ExtremeSwitching SLX 9030 Series
- Extreme Networks ExtremeSwitching SLX 9030-48S
- Extreme Networks ExtremeSwitching SLX 9030-48T
- Extreme Networks ExtremeSwitching SLX 9150
- Extreme Networks ExtremeSwitching SLX9150-48Y-8C
- Extreme Networks ExtremeSwitching SLX9150-48Y-8C-AC-F
- Extreme Networks ExtremeSwitching SLX9150-48Y-8C-AC-R
- Extreme Networks ExtremeSwitching SLX9150-48XT-6C
- Extreme Networks ExtremeSwitching SLX9150-48XT-6C-AC-F
- Extreme Networks ExtremeSwitching SLX9150-48XT-6C-AC-R
- Extreme Networks ExtremeSwitching SLX 9250
- Extreme Networks ExtremeSwitching SLX9250-32C
- Extreme Networks ExtremeSwitching SLX9250-32C-AC-F
- Extreme Networks ExtremeSwitching SLX9250-32C-AC-R
- Extreme Networks ExtremeSwitching SLX 9140
- Extreme Networks Summit4/FX