Table of Contents
Advertisement
Service Port - The numbers of External Ports. You can type a service port or a
range of service ports (the format is XXX – YYY, XXX is Start port, YYY is End
port).
IP Address - The IP address of the PC running the service application
Protocol - The protocol used for this application, either TCP, UDP, or All (all
protocols supported by the router).
Enable - The Enable checkbox to enable the virtual server entry.
Common Service Port - Some common services already listed in the pull-down
list.
To setup a virtual server entry:
1.
Select the service you want to use from the Common Service Port list, select the ID
you want to use, and click the Copy to button. If the Common Service Port list
does not have the service that you want to use, type the number of the service port
or service port range in the Service Port box.
2.
Type the IP address of the computer in the Server IP Address box.
3.
Select the protocol used for this application, either TCP,UDP, or All.
4.
Select the Enable checkbox to enable the virtual server.
5.
Click the Save button.
Note: It is possible that you have a computer or server that has more than one type of
available service. If so, select another service, and enter the same IP address for that
computer or server.
To modify a virtual server entry:
1.
Select the entry you want to modify.
2.
Modify the information from the Service Port, the IP Address boxes, and the
Protocol pull-down list.
TL-R460
Cable/DSL Router User Guide
Figure 5-14 Virtual Servers
- 22 -
Advertisement
Table of Contents
