TP-Link TL-R460 User Manual page 21

TL-R460 Cable/DSL Router User Guide
that you wish to have the Internet connecting last unless a new link is requested.
Caution: Sometimes the connection cannot be disconnected although you specify a
time to Max Idle Time. This is because there may still be active applications in the
background, which may cause fee accounted by your ISP.
Click the Connect button to connect immediately, Click the Disconnect button to
disconnect immediately.
Click the Advanced Settings button to set up the advanced option, the page shown
in figure 5-7 will then appear:
Figure 5-7 PPPoE Advanced Settings
Packet MTU - The default MTU size is 1492 bytes, which is usually fine. For some
ISPs, you need modify the MTU. This should not be done unless you are sure it is
necessary for your ISP.
Service Name/AC Name - The service name and AC (Access Concentrator) name,
this should not be done unless you are sure it is necessary for your ISP.
ISP Specified IP Address - If you know that your ISP does not automatically
transmit your IP address to the router during login, click "Use the IP Address
specified by ISP" check box and enter the IP address in dotted-decimal notation,
which your ISP provided.
Detect Online Interval - The default value is 0, you can input the value between 0
and 120. The router will detect Access Concentrator online at every interval between
seconds. If the value is 0, it means do not detect.
DNS IP Address - If you know that your ISP does not automatically transmit DNS
addresses to the router during login, click "Use the following DNS servers"
checkbox and enter the IP address in dotted-decimal notation of your ISP's primary
DNS server. If a secondary DNS server address is available, enter it as well.
Click the Save button to save your settings.
- 17 -