Dhcp Settings; Dhcp Clients List - TP-Link TL-WA5110G User Manual

5.7.1 DHCP Settings

The router is set up by default as a DHCP (Dynamic Host Configuration Protocol) server, which
provides the TCP/IP configuration for all the PC(s) that are connected to the router on the LAN.
The DHCP Server can be configured on the page (shown in Figure 5-19):
DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must
have another DHCP server within your network ，or else you have to manually configure
the computer.
Start IP Address - This field specifies the first of the addresses in the IP address pool.
192.168.1.100 is the default start address.
End IP Address - This field specifies the last of the addresses in the IP address pool.
192.168.1.199 is the default end address.
Address Lease Time - The Address Lease Time is the amount of time in which a network
user will be allowed to connect to the router with their current dynamic IP Address. Enter the
amount of time in minute. The user will be "leased" this dynamic IP Address. The range of
the time is 1 ~ 2880 minutes. The default value is 120 minutes.
Default Gateway - (Optional.) Suggest to input the IP address of the LAN port of the router,
default value is 192.168.1.1
Default Domain - (Optional.) Input the domain name of your network.
Primary DNS - (Optional.) Input the DNS IP address provided by your ISP. Or consult your
ISP.
Secondary DNS - (Optional.) Input the IP address of another DNS server if your ISP
provides two DNS servers.
Note:
To use the DHCP server function of the router, you must configure all computers on the LAN as
"Obtain an IP Address automatically" mode. This function will take effect until the router reboots.
Click Save to save the new settings to the router

5.7.2 DHCP Clients List

This page shows Client Name, MAC Address, Assigned IP, and Lease Time for each DHCP
Client attached to the router Figure 5-20.
Figure 5-19 DHCP Settings
77