Changing The Hydraulic Oil Filter - Husqvarna Wacker Neuson CRT60-74LX Operator's Manual

CRT60-74LX
6.10

Changing the Hydraulic Oil Filter

The machine has a hydraulic oil filter to collect particulates from oil. The filter (a) is
located behind the access panel (b) at the front of the machine.
NOTICE: Replace the hydraulic filter regularly to avoid damaging the hydraulic
system.
When ■ Replace the hydraulic oil filter after the first 50 hours, and with every hydraulic
oil change.
■ In hot climates exceeding 32°C (90°F), replace the hydraulic oil and hydraulic oil
filter every 250 hours.
■ In climates below 32°C (90°F), replace the hydraulic oil and hydraulic oil filter
every 500 hours.
Requirements ■ Machine shut down
■ New hydraulic oil filter
■ Plastic cloth and a container of sufficient volume to collect drained oil
■ Wrench
Procedure Perform the procedure below to replace the hydraulic oil filter.
1. Place a collection container below the filter.
2. Remove the access panel.
3. Using a wrench, twist the hex stud (c) counterclockwise to unscrew the filter
canister. Remove the old filter.
Note: Discard the old filter in accordance with current environmental protection
regulations.
WARNING
Most used hydraulic oil contains small amounts of materials that can cause cancer
and other health problems if inhaled, ingested, or left in contact with skin for pro-
longed periods of time.
► Take steps to avoid inhaling or ingesting used hydraulic oil.
► Wash skin thoroughly after exposure to used hydraulic oil.
This procedure continues on the next page.
wc_tx004561gb.fm
b
a
73
Maintenance
c
wc_gr012727