Adjusting The Pitch - Husqvarna Wacker Neuson CRT60-74LX Operator's Manual

CRT60-74LX
5.9

Adjusting the Pitch

Changing the pitch (angle) of the trowel blades enables the operator to finish
concrete from the wet surface stage through the hard finishing stage (burnishing).
Procedure Perform the procedure below to change or set the pitch angle of the trowel blades.
1. Slow the machine.
2. Set the desired pitch on the left side of the machine.
■ To increase the pitch, press the left front button (e1) on the left joystick.
■ To decrease the pitch, press the left rear button (e2) on the left joystick.
3. Adjust the right side to match, using buttons (a1, a2) on the right joystick.
Suggested
working pitch
Working conditions of concrete
1. Wet surface working stage
2. Wet to plastic working stage
3. Semi-hard working stage
4. Hard finishing stage (burnishing)
wc_tx003645gb_FM10.fm
e1
e2
49
a1
a2
Suggested working pitch
Flat (no pitch)
Slight pitch (5–10°)
Additional pitch (15°)
Maximum pitch (20–25°)
Operation
5-10 ¢
15¢
20-25¢
wc_gr014517