Table of Contents
Advertisement
On the right, next to the talk key is the channel indicator LED. It tells you
whether the talk key is activated or not.
The call light indicator is located on the top of the housing.
On the underside of the unit, you will find the XLR connectors for connecting
and looping through the intercom line (3-pin), as well as a 4-pin XLR for the
headset.
On the back of the unit are two sidetone trimmers, the BP-2001 only uses the
upper one.
2.4 Connecting the beltpack to a Riedel Party Line (RPL)
The beltpack is a portable headset station powered through the intercom
wiring using the PS-2002 or PS-2004 power supply.
The beltpack is connected to the party line via a 3-pin XLR plug and is ready
for use immediately. The headset is connected via the 4-pin XLR male headset
connector.
3 Operation
3.1 Talk
3.1.1 Talk key properties
The
Talk
key
has
touch
and
latch
function.
Pressing
the
key
briefly
represents the latch function for switching on and off. If the key is held
down for a longer period, the touch function will be activated. In this case,
the Talk function will be active for as long as the key is held down.
3.1.2 Talking to the intercom channel
Press Talk key "I" to talk to intercom channel I. The active Talk function is
indicated by the corresponding LED.
3.2 Listen
A volume control is provided on the right-hand side of the unit. To increase
the volume, rotate the knob clockwise.
Note: If the headset is put down and the Talk function is active, depending
on the volume of the headset, feedback can occur.
Therefore, before putting
the headset down, always switch off the Talk function. Activated Talk keys
can be switched off remotely using the "Mic Kill" function on the MS-2004 and
MS-2002 master stations.
3.3 Call Light
3.3.1 Sending a call light signal
You can only send a call light signal to a channel where the Talk function
has been activated. If the channel is switched to "Talk", the corresponding
LED indicator lights up.
By pressing the call light key marked "L", the call
light signal is sent to the intercom line.
The call light illuminates on all
Page 5 of 11
Advertisement
Table of Contents
