Advertisement
Figure 11
1. Guard wing—initial
position
3. Use the 2 shoulder bolts, 2 spacers, and 2
flange nuts to attach each latch-arm link to each
guard wing
(Figure
Figure 12
1. Shoulder bolt
2. Latch-arm link
4. Install the guard assembly to the brackets as
shown in
Figure
13.
Note:
Ensure that the guard is centered. Use
the holes in the guard frame that align with holes
in the brackets.
2. Guard wing—final position
12).
3. Spacer
4. Flange nut
g198197
1. Short carriage screw (8)
2. Guard assembly
5. Tighten the flange nuts to secure the brackets to
the roll bar
6. Check the clearance between the hood of the
machine and the guard assembly. If the hood of
the machine contacts the guard assembly when
you open the hood, move the guard assembly
higher on the roll bar until the hood no longer
contacts the guard assembly.
7. Ensure that all fasteners are tight.
g198332
5
Figure 13
3. Flange nut (8)
(Figure
10).
g211695
Advertisement
