Advertisement
Figure 5
1. Short carriage screw (8)
2. Guard assembly
5. Tighten the flange nuts to secure the brackets to
the roll bar
(Figure
6. Check the clearance between the hood of the
machine and the guard assembly. If the hood of
the machine contacts the guard assembly when
you open the hood, move the guard assembly
higher on the roll bar until the hood no longer
contacts the guard assembly.
7. Ensure that all fasteners are tight.
3. Flange nut (8)
2).
Installing the Guard on a
Reelmaster 3555/3575 Series
Traction Unit
1. Loosely mount the brackets to the roll bar as
shown in
g198626
1. Right mounting bracket
2. Left mounting bracket
3. Flange nut (4)
2. Swing the guard wings forward as shown in
Figure
7.
1. Guard wing—initial
position
3
Figure
6.
Figure 6
4. Mount strap (4)
5. Carriage bolt—3/8 x 4-1/2
inch (4)
6. Front of the machine
Figure 7
2. Guard wing—final position
g198449
g198197
Advertisement
