Advertisement
3. Use the 2 shoulder bolts, 2 spacers, and 2
flange nuts to attach each latch-arm link to each
guard wing
(Figure
Figure 8
1. Shoulder bolt
2. Latch-arm link
4. Install the guard assembly to the brackets as
shown in
Figure
9.
Note:
Ensure that the guard is centered. Use
the holes in the guard frame that align with holes
in the brackets.
Figure 9
1. Short carriage screw (8)
2. Guard assembly
8).
3. Spacer
4. Flange nut
3. Flange nut (8)
5. Tighten the flange nuts to secure the brackets to
the roll bar
6. Check the clearance between the hood of the
machine and the guard assembly. If the hood of
the machine contacts the guard assembly when
you open the hood, move the guard assembly
higher on the roll bar until the hood no longer
contacts the guard assembly.
7. Ensure that all fasteners are tight.
Installing the Guard on a
Reelmaster 5010 Series or
Groundsmaster 4300-D Series
Traction Unit
g198332
1. Loosely mount the brackets to the roll bar as
shown
Figure
1. Right mounting bracket
2. Left mounting bracket
3. Flange nut (4)
2. Swing the guard wings forward as shown in
g198626
Figure
11.
4
(Figure
6).
10.
Figure 10
4. Mount strap (4)
5. Carriage bolt—3/8 x 3-1/2
inch (4)
6. Front of the machine
g211694
Advertisement
