Cisco CX-AIP-TM Installation And Configuration Manual page 43

•
Use the show version command to display the configuration of the system hardware (the number
of each interface processor type installed), the software version, the names and sources of
configuration files, and the boot images.
The following sample shows the output of the show version command from a Cisco 7513:
Router> show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (RSP-JV-MZ), Released Version 11.1(10)CA [biff 135]
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled Mon 10-Mar-97 10:06 by biff
Image text-base: 0x600108A0, data-base: 0x60982000
ROM: System Bootstrap, Version 11.1(2) [biff 2], RELEASE SOFTWARE (fc1)
ROM: GS Bootstrap Software (RSP-BOOT-M), Version 10.3(8), RELEASE SOFTWARE (fc2)
Router uptime is 23 minutes
System restarted by reload
System image file is "biff/rsp-jv-mz", booted via tftp from 1.1.1.254
cisco RSP2 (R4600) processor with 32768K bytes of memory.
R4700 processor, Implementation 33, Revision 1.0
Last reset from power-on
G.703/E1 software, Version 1.0.
SuperLAT software copyright 1990 by Meridian Technology Corp).
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
TN3270 Emulation software (copyright 1994 by TGV Inc).
Chassis Interface.
(additional displayed text omitted from this example)
1 AIP controller (1 ATM)
1 ATM network interface
(additional displayed text omitted from this example)
123K bytes of non-volatile configuration memory.
8192K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
No slave installed in slot 7.
Configuration register is 0x0
•
Use the show atm traffic command to display the interface traffic, as follows:
Router# show atm traffic
4915 Input packets
0 Output packets
2913 Broadcast packets
0 Packets for non-existent VC
0 Packets with CRC errors
0 OAM cells received
0 Cells lost
•
Use the show sscop command to display SSCOP details for the ATM interface.
•
Use the show protocols command to display the global (system-wide) and interface-specific
status of any configured Level 3 protocol.
Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
Configuring the AIP
43