Table of Contents
Advertisement
Interface Processor Replacement Procedures
Step 3
Figure 8
Interface processor
card slot
Step 4
Caution
only.
22 Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
Interface processors and interface processor fillers are secured with two captive
installation screws. (See Figure 8a.) Use a flat-blade screwdriver to loosen the captive
installation screws and remove the interface processor filler (or the existing interface
processor) from the slot. If you remove an interface processor, immediately place it in an
antistatic bag to prevent damage from electrostatic discharge.
Location of Ejector Levers and Captive Installation Screws
Ejector
lever
Interface processor card
carrier guide (black)
a
Captive
installation
screw
c
Hold the interface processor handle with one hand, and place your other hand under the
carrier to support the interface processor (see Figure 7); guide the carrier into the slot.
Avoid touching the card or any connector pins.
To prevent ESD damage, handle interface processors by the handles and carrier edges
b
Advertisement
Table of Contents
