Cisco CX-AIP-TM Installation And Configuration Manual page 25

•
For E3 and DS3 connections, use the 75-ohm, RG-59 coaxial cable CAB-ATM-DS3/E3, which
has bayonet-style, twist-lock (BNC) connectors and ferrite beads. (See Figure 13.) The E3 and
DS3 PLIMs both require cable CAB-ATM-DS3/E3.
Figure 13 CAB-ATM-DS3/E3 Cable (RG-59 Coaxial Cable with BNC Connectors)
White insulator
To ensure compliance with EMI standards, the E3 PLIM connection requires an EMI filter
Caution
clip (CLIP-E3-EMI) on the receive port (RCVR); the DS3 PLIM connection does not require this
clip.
•
For multimode connections, connect the multimode interface cable to the MIC connector.
(See Figure 14.)
Figure 14 MIC Connector on a TAXI 4B/5B PLIM
Note To ensure correct operation of the TAXI, E3, and DS3 AIPs, Hardware Revision 1.3 (shipped
from March 1995), the following minimum Cisco IOS release levels are required: Release 10.0(9),
10.2(5), 10.3(1) or later.
Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
Ferrite beads
ATM Interface Cables
White insulator
25