Cisco Firepower 2100 Series Getting Started Manual page 97

ASA Deployment in Platform Mode
To set the gateway to the ASA data interfaces, set the gw to 0.0.0.0. This is the default setting.
Example:
firepower-2110 /fabric-interconnect # set out-of-band static ip 192.168.4.1 netmask
255.255.255.0
Warning: When committed, this change may disconnect the current CLI session
firepower-2110 /fabric-interconnect* #
Step 4 Configure an IPv6 management IP address and gateway.
a) Set the scope for fabric-interconnect a, and then the IPv6 configuration.
scope fabric-interconnect a
scope ipv6-config
Example:
firepower-2110# scope fabric-interconnect a
firepower-2110 /fabric-interconnect # scope ipv6-config
firepower-2110 /fabric-interconnect/ipv6-config #
b) View the current management IPv6 address.
show ipv6-if
Example:
firepower-2110 /fabric-interconnect/ipv6-config # show ipv6-if
Management IPv6 Interface:
c) Configure a new management IPv6 address and gateway:
Firepower-chassis /fabric-interconnect/ipv6-config # set out-of-band static ipv6 ipv6_address ipv6-prefix
prefix_length ipv6-gw gateway_address
To keep the currently-set gateway, omit the ipv6-gw keyword. Similarly, to keep the existing management
IP address while changing the gateway, omit the ipv6 and ipv6-prefix keywords.
To set the gateway to the ASA data interfaces, set the gw to ::. This is the default setting.
Example:
firepower-2110 /fabric-interconnect/ipv6-config # set out-of-band static ipv6 2001:DB8::34
ipv6-prefix 64 ipv6-gw 2001:DB8::1
firepower-2110 /fabric-interconnect/ipv6-config* #
Step 5
Delete and add new access lists for HTTPS, SSH, and SNMP to allow management connections from the new
network.
a) Set the scope for system/services.
scope system
IPv6 Address
----------------------------------- ---------- ------------
::
(Optional) Change the FXOS Management IP Addresses or Gateway
Prefix IPv6 Gateway
:: ::
Cisco Firepower 2100 Getting Started Guide
95