Before You Start; End-To-End Procedure - Cisco Firepower 2100 Series Getting Started Manual

Before You Start

•
•
Before You Start
Deploy and perform initial configuration of the FMC. See the
Note The Firepower device and the FMC both have the same default management IP address: 192.168.45.45. This
guide assumes that you will set different IP addresses for your devices during initial setup.

End-to-End Procedure

See the following tasks to deploy the FTD with FMC on your chassis.
Cisco Firepower 2100 Getting Started Guide
24
Power Off the Device, on page 50
What's Next?, on page 50
Firepower Threat Defense Deployment with FMC
FMC getting started guide.