Cisco Firepower 2100 Series Getting Started Manual page 22

Access the FTD and FXOS CLI
Note You can alternatively SSH to the Management interface of the FTD device. You can later connect to the
address on a data interface if you open the interface for SSH connections. SSH access to data interfaces is
disabled by default. This procedure describes console port access.
Procedure
Step 1
To log into the CLI, connect your management computer to the console port. See the hardware guide for your
device for more information about the console cable. Use the following serial settings:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
Attention
Step 2
At the prompt, log into the FXOS CLI.
Example:
firepower login: admin
Password:
Last login: Thu May 16 14:01:03 UTC 2019 on ttyS0
Successful login attempts for user 'admin' : 1
firepower#
Step 3
Access the FTD CLI.
connect ftd
Example:
firepower# connect ftd
>
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see the Cisco Firepower Threat Defense Command
Step 4 To exit the FTD CLI, enter the exit or logout command.
Example:
> exit
firepower#
Cisco Firepower 2100 Getting Started Guide
20
The CLI on the console port is FXOS.
Firepower Threat Defense Deployment with FDM
Reference.