Cable The Device - Cisco Firepower 2100 Series Getting Started Manual

Cable the Device

Figure 11: Edge Network Deployment
Cable the Device
To cable one of the above scenarios on the Firepower 2100, see the following steps.
Note
The Firepower 2100 and the FMC both have the same default management IP address: 192.168.45.45. This
guide assumes that you will set different IP addresses for your devices during initial setup.
Note Other topologies can be used, and your deployment will vary depending on your basic logical network
connectivity, ports, addressing, and configuration requirements.
Procedure
Step 1 Cable for a separate management network:
Cisco Firepower 2100 Getting Started Guide
28
Firepower Threat Defense Deployment with FMC