Outline Of Operation - TEC EM1-31064 Owner's Manual

10. OUTLINE OF OPERATION

10. OUTLINE OF OPERATION
Since there is a cutter at the paper outlet, be careful not to injure your fingers when
issuing labels.
1
Press the
POWER key
Menu No. 1
REG Menu
(Refer to Section 14)
POWER key
No Press
ESC. key
No Press
Return to
each mode
NOTES:
1. You can register a password to prohibit unauthorized access to each menu expect for REG.
menu.
2. To avoid wasteful use of the display, press the POWER key to turn the display off while being
unused. Pressing the POWER key again allows you to enter REG. mode without scanning.
3. Refer to respective sections for explanation each menu enclosed by a double rectangle.
4. In the self service scale mode (the initial setting #13-2 is set to 1) the POWER , and ESC.
keys are available in the following cases.
POWER key:
ESC. key:
5. In the self service scale mode (the initial setting #13-2 is set to 1), these keys are unavailable.
If you would like to switch the initial setting #13-2 to 1, please contact your authorized TOSHIBA TEC
representative.
WARNING!
Main Power
Switch ON
Display OFF
Press the
POWER key
Scanning Display
NOTE4 Menu
#1
Press
ESC Key
2
No Press
Necessary
Password Input
Menu No. 2
MARK DOWN
Menu
(Refer to Section 14)
Menu No. 3
REWRAP Menu
(Refer to Section 14) (Refer to Section 11)
NOTE5
Press
Display OFF
NOTE5
Press
2
Available after the main power switch turns ON.
Available after the POWER key is depressed while scaling.
2
Main Menu
NEXT
or
VOID
PLU
Increment Decrement
Select the
Menu #
Other than Menu #1.
Unnecessary
Password
Menu No. 5
READ Menu
(Refer to Section 12, 15)
Menu No. 0
PROG Menu RESET Menu
(Refer to Section 15)
1
<Menu>
0. PROG.
1. REG
2. MARK DOWN
3. REWRAP
4. SECURITY
10-1
10. OUTLINE OF OPERATION
Menu No. 4
SECURITY
Menu
(Refer to Section 13)
Menu No. 6
5. REPORT
6. RESET
7.
8.
9.
EM1-31064