Nosmell Active Charcoal Filters; Resetting The Charcoal Filter Operating Hours Counter; Disposing Of The Charcoal Filters - Miele DA 3668 Operating And Installation Instructions

Cleaning and care

NoSmell active charcoal filters

With recirculation mode, two charcoal
filters must be fitted in addition to the
grease filters. These are designed to
absorb cooking odours.
Charcoal filters are available to order via
the Miele online shop (see the end of
this booklet for contact details) or
directly from Miele.
The part number of the charcoal filter
required is listed under "Technical data".
Fitting/replacing the charcoal filters
The slots for the charcoal filters are
located above the grease filters.
 Remove the cover. It is held in place
by magnets.
 Take the charcoal filters out of their
packaging.
 Insert the charcoal filters in the slots.
 Replace the cover.
44
When to change the NoSmell active
charcoal filters
Replace the charcoal filters when they
no longer absorb kitchen odours
effectively, or at least every 6 months.
The operating hours counter will remind
you to replace the charcoal filters by
lighting up the charcoal filter symbol .
Resetting the charcoal filter
operating hours counter
After changing the charcoal filters, the
operating hours counter needs to be re-
set.
 To do this, with the fan switched on,
press the operating hours control
 twice, then press it again and
hold it for approx. 3 seconds until
only 1 is flashing.
The charcoal filter symbol  goes out.
If you want to replace the charcoal
filters before the operating hours
counter has reached its maximum:
 Press the operating hours control
 twice and hold it for approx. 6
seconds until only 1 is flashing.

Disposing of the charcoal filters

 Used charcoal filters can be disposed
of with the normal household waste.