Miele DA 362-75 Operating And Installation Instructions
  1. Manuals
  2. Brands
  3. Miele Manuals
  4. Ventilation Hood
  5. DA 362-75
  6. Operating and installation instructions
Miele DA 362-75 Operating And Installation Instructions

Miele DA 362-75 Operating And Installation Instructions

Ventilation system
Hide thumbs Also See for DA 362-75:
Table of Contents

Advertisement

Quick Links

Operating and Installation
Instructions
Ventilation System
DA 362-75
DA 362-110
UV
To prevent accidents
and machine damage,
read these instructions
installation or use.
M.-Nr. 06 191 500

Advertisement

Table of Contents
loading

Related Manuals for Miele DA 362-75

Summary of Contents for Miele DA 362-75

  • Page 1 Operating and Installation Instructions Ventilation System DA 362-75 DA 362-110 To prevent accidents and machine damage, read these instructions installation or use. M.-Nr. 06 191 500...

  • Page 2: Table Of Contents

    Main power switch ..........10 Joystick .
  • Page 3 This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage.
  • Page 4 However, under certain conditions it may be possible for an installation in these applications. Please contact the nearest Miele dealer or the Technical Service Department with specific requirements. Before servicing or cleaning the unit, switch power off at the service...
  • Page 5 Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers may ignite. Heat oils slowly on low or medium settings. Always turn the hood “ON” when cooking at high heat or when cooking flaming foods. Clean ventilating fans frequently. Grease should not be allowed to accumulate on the fan or filter.
  • Page 6 When installing the hood, follow the recommended minimum safety distances between a Miele cooktop and the hood: – 22" (55 cm) above electric cooktops, – 26" (65 cm) above gas cooktops, – 26" (65 cm) above an open grill. If local building codes require a greater safety distance, follow their requirement.
  • Page 7 The active charcoal filters may be purchased from your Miele dealer or Miele’s Technical Service Department. Before using the hood in recirculation mode, ensure that the active charcoal filters are in place, see "Cleaning and Care".

  • Page 9: Joystick

    The fan and light can be operated with the joystick. additional accessory DA 362-75 two filters DA 362-110 four filters only for the DA 362-110 This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes.

  • Page 10: Main Power Switch

    only for the DA 362-110 Press the main power switch to "l" to use the fan and lighting. If the appliance is not going to be used for a long period of time (e.g. while vacationing) it should be turned off ("0") at the main power switch.
  • Page 11 ^ Press the joystick once to the right. The fan runs at power level “lI” and the second indicator of the fan power scale lights. ^ Press the joystick to the right, to increase the fan speed. The corresponding indicator of the fan power scale lights.

  • Page 12: Delayed Shut Down

    If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the Delayed Shut Down button while the fan is still running: Press once = 5 minutes delay (left indicator lights)

  • Page 13: Filter Timers

    A timer monitors the hours of operation. The indicator for the grease filter will light after 30 hours of fan operation. The grease filters must then be cleaned. After the grease filter has been cleaned and put back in place, the grease filter timer must be reset.
  • Page 14 The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. – A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. –...
  • Page 15 The active charcoal filter can only be used in recirculation mode and can not be used to exhaust fumes. The charcoal filter timer is Before using the hood in recirculation mode, the charcoal filter timer must be programmed. ^ Press the joystick to the left to turn the fan off.
  • Page 16 Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Warning: Never use abrasive cleansers, scouring pads, steel wool or caustic (oven) cleaners on the hood.
  • Page 17 The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). The grease filters should be cleaned every 3-4 weeks or whenever the grease filter indicator lights. A dirty filter is a fire hazard. ^ To remove the grease filters release the latch.
  • Page 18 When putting the grease filters back make sure that the locking clips are visible facing down towards the cooking surface. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing.
  • Page 19 In recirculation mode four active charcoal filters must be used in addition to the grease filters. The charcoal filters are designed to absorb cooking odors. They are located in the canopy above the grease filters. Active charcoal filters can be ordered from Technical Service.
  • Page 20 Before changing the light bulb, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool down.
  • Page 21 In the event of a fault which you can not correct yourself please contact the Miele Technical Service Department 1-800-999-1360 techserv@mieleusa.com 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed.
  • Page 23 Installation Instructions...
  • Page 24 The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. To prevent suffocation of children, ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of their reach. Old appliances may contain materials that can be recycled.
  • Page 25 All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer can not be held responsible for unauthorized work. Ensure that power to the appliance is "OFF"...
  • Page 26 A depth , min. 1 " (40 mm), is necessary in the rear of the cabinet.
  • Page 27 A depth , min. 1 " (40 mm), is necessary in the rear of the cabinet.
  • Page 28 Do not install this hood over any appliance that burns solid fuel. allowed between the top of a Miele cooking surface and the bottom of the hood is: – 22" (55 cm) above electric cooktops – 26" (65 cm) above gas cooktops –...
  • Page 29 The hood is designed to be installed within cabinetry and kitchen islands. The top half (motor and fan assembly) should be accessible after installation. If the motor and fan assembly are not accessible, assemble the ductwork and the electical connection installation.
  • Page 30 ^ Place the exhaust connections at the top of the motor assembly so that the flaps open in the "up" direction. ^ Turn the non-return flaps slightly to the left to lock them in place. ^ If using 5" (125 mm) ducting, place the reducing collars into the exhaust connections and turn left to lock them in place.

  • Page 31: Active Charcoal Filters

    For recirculation mode the following accessories can be ordered from your Miele dealer or the Technical Service Department: – 1 conversion kit for recirculation mode – 2 active charcoal filters –...
  • Page 32 In recirculation mode, one cut out must be made, where the ducting ends, for the installation of the recirculation vents, b. If installing the hood over an island or in a cabinet at ceiling height, a suitable cut-out has to be made in the front panel, d.
  • Page 33 ^ Insert the lower half of the desired joystick into the socket, loosely secure it in place with the included screw and spring washer. The screws have different lengths. Make sure the respective screw for the desired joystick is used. ^ Turn the printed part of the joystick so that the m-symbol faces front.
  • Page 34 Before connecting the appliance to power read the "Important Safety Instructions". ^ Plug in the power cord. ^ Before using the appliance remove the grease filters and remove the protective foil from the filter frame. Insert the grease filters back into place.
  • Page 35 1/8" per foot (1 cm per meter) to prevent condensation dripping into the appliance. – If the exhaust is ducted through an outside wall, a Miele Telescopic Wall Vent can be used. – If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue.
  • Page 36 Never connect an exhaust hood to an active chimney, dryer vent, vent flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. If the ductwork runs through rooms, ceilings, garages, etc.
  • Page 40 Alteration rights reserved / 1604 M.-Nr. 06 191 500 / 00 This paper was bleached without the use of chlorine.

This manual is also suitable for:

Da 362-110

Table of Contents