Related Manuals for Miele DA 360
Summary of Contents for Miele DA 360
- Page 1 Operating and installation instructions Cooker Hood DA 360 To avoid the risk of accidents or damage to the machine it is to read these instructions before it is installed or used for the first time. M.-Nr. 05 609 600...
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . - Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
- Page 4 This appliance complies with all Before connecting the appliance to relevant local and national safety the mains supply, make sure that requirements. Inappropriate use the voltage and frequency details given can, however, lead to personal injury on the data plate correspond with the and damage to property.
- Page 5 The appliance is only completely Always switch the cooker hood on isolated from the electricity supply when a cooking zone is in use, when: otherwise condensation may collect in the hood, which could cause corrosion. – it is switched off at the wall socket and the plug removed.
- Page 6 All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts Department (see back cover for contact details) or from builders’ merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 7: Warning And Safety Instructions
When using the cooker hood at the same time as another heating For appliances with an external appliance which depends on the air in motor fitted (EXT models) the the room (e.g. gas, oil or coal fired connection of the two units must be heaters, continuous flow or other water made using the connection cable and heaters, gas cooker, gas hob or gas... - Page 9 ^ Set the sliding switch a for the fan to The hob lighting b can be switched on "1". and off independently of the fan. "0" – lighting off "1" – lighting on You can select one of three power levels with the sliding switch a depending on how much the air needs to be filtered.
- Page 10 The cooker hood works with The air is drawn in and cleaned by the grease filters and then directed outside. If the on-site ventilation system does not have a non-return flap, the supplied must be fitted. This flap is closed when the cooker hood is switched off.
- Page 11 If you are unsure about a particular following cleaning instructions: product or need further advice please contact your nearest Miele Sales ^ All external surfaces and controls can office. See back page for address. be cleaned using warm water with a little washing up liquid applied with a well wrung out soft sponge or cloth.
-
Page 12: Housing
^ After cleaning leave the filter to dry for a while on an absorbent surface before putting them back in place. ^ When removing the filter for cleaning also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. - Page 13 They are fitted in the canopy above the grease filter. Active charcoal filters can be obtained from your dealer or the Miele Spare Parts Department. Refer to the section "Technical data" for type and reference number. ^ Before fitting or replacing the active...
- Page 14 If the lighting is not working the compact light tube and/or starter may need to be changed. Disconnect the cooker hood from the mains supply. Ensure that: - it is switched off at the wall socket and the plug has been withdrawn (do not pull on the cable, only on ^ Push the light tube to the left to the plug), or...
- Page 15 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
- Page 16 * Cut-out size A depth of at least 40 mm must be provided at the back of the building in niche.
-
Page 17: Exhaust Connection
^ Turn the non-return flap slightly Safety regulations prohibit the fitting anti-clockwise to secure it. of this cooker hood over a solid fuel stove. The minimum safety distance between the top of the cooker/hob and the bottom of the cooker hood should be at least: - 450 mm above electric cookers and hobs,... -
Page 18: Electrical Connection
The cooker hood is intended to be built-into wall units, cooker hood housing units, and above breakfast bars or island areas. Check prior to installation that the top of the appliance will be accessible after installation. If this is not the case, install the exhaust ducting and prepare the electrical connection installation. - Page 19 (i.e, extractor canopies, ceiling The following parts, available through mounted units) then an appropriate your Miele Dealer or from the Miele cut-out must be made in the front panel d . Spare Parts Department are required for operating the appliance in...
- Page 20 – Where ducting is horizontal it must Danger of toxic fumes. be laid to slope away at at least 1 cm Please heed the "Warning and per metre. Safety instructions" to avoid the This is to ensure that condensate danger of toxic fumes. cannot drain back into the cooker The cooker hood should be installed hood.
-
Page 21: Condensate Trap
If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of sweating or condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. - Page 22 For extra safety it is advisable to install All electrical work should be a residual current device (RCD) with a undertaken by a suitably qualified trip current of 30 mA. and competent person in strict accordance with national and local safety regulations.
- Page 23 Rated load ....278 W Lighting ....1 x 18 W Extraction power according to EN 61591 Extraction system C 125 mm: Voltage .
- Page 24 Alteration rights reserved / 4804 M.-Nr. 05 609 600 / 03 en - GB...