Summary Screen - HP ProLiant MicroServer Maintenance And Service Manual

Press Enter twice without entering anything in the new and confirm password fields.
3.
Press F10 to save the changes you made and close the Setup Utility.
4.
The Admin Password field value is set to Clear.
To reset the admin password:
If you forget the admin password, you need to clear the CMOS and reset the BIOS settings to regain
access the Setup Utility. For instructions, refer to the
Exit menu
Field
Save Changes and Exit
Discard Changes and Exit
Discard Changes
Load Optional Defaults

Summary screen

The Summary screen displays basic and important information about the current server configuration
and is necessary for troubleshooting and may be required when asking for technical support. It is
recommended that you check this screen during the initial system setup and each time you install,
remove, or upgrade accessories.
To view the Summary screen:
You first need to enable the display of the Summary screen during bootup. Follow the steps below.
"Clearing CMOS"
Description
Saves changes made and closes the Setup Utility.
Keyboard shortcut: F10
Discards changes made and closes the Setup Utility.
Discards all changes made to the Setup Utility and loads the previous
configuration settings.
Loads the factory-default settings for all Setup fields.
Keyboard shortcut: F9
section on page 97.
Diagnostic tools 78