TEC EO1-13016 Owner's Manual page 16

5. INSTALLATION PROCEDURE
3) Connect and secure the interface cable to the interface connector in the correct orientation.
Serial interface:
Parallel interface:
Serial Interface Cable
[Serial Interface Type]
4) Connect the interface cable to the TOSHIBA TEC POS terminal, and then plug in the power cord
to the AC outlet.
NOTE: The above figure shows the example of the interface cable which is connected to the LPT1
port (Parallel interface) on the ST-5600 POS terminal.
Secure the connector with the screws.
Secure the connector with the locking tabs.
Serial Interface Connector
Interface Cable
5.1 Connecting the Power Cord and Interface Cable
Locking Tab
Parallel Interface Cable
[Parallel Interface Type]
LPT1
5- 2
Parallel Interface Connector
Locking Tab
EO1-13016