Advertisement
Cobra Electronics
UI/Functional Specification
Model: MR HH150 USA and EU
MARINE STANDBY MODE – Continue
10) MEM / ESC Key
MEM KEY:
Press and release to enter Memory mode. MEM and memory channel icons turns on.
First memory location is "0", last is "9"
Push and Hold MEM key for 2 seconds to enter memory channel program mode.
Memory channel number blinks.
Channel up/down keys change memory channel number. Push and hold to scroll.
Push and release MEM key to change to receiver channel number (the two main LCD digits).
Main channel digits blink and channel up/down keys change channel number.
Setting the Main channel number to zero clears this memory location.
Push and release MEM key goes back to memory channel number (blinking).
ESC KEY:
Functions as ESC key to cancel and exit during setup mode functions unless
specified in other function calls..
11) Dual Watch / Scan Key – Scan operation
Push and hold for two seconds to scan all channels.
Direction of scan by default is from Lower to higher channel. User can change scan direction with
CH UP/DOWN keys.
When a signal is received; unit will pause for 10 seconds before resuming Scan.
Unit will cease scanning when PTT is activated.
In MEM mode, push and release to scan all memory channels.
If only one memory channel is stored, then sound 3 error beeps – no scanning.
While in scan mode, all other keys function as follows:
PTT – exit SCAN and return to standby on last active SCAN channel or
last used standby channel if no activity during SCAN.
Backlight / lock - push and hold to lock/ push and release to turn on
Back light for 10 seconds.
16 key – push and release exit SCAN and go to channel 16, push again go
to last active SCAN channel or last used standby channel if no activity during SCAN.
Empty memory channel 0
7
Issue: Preliminary R2
Advertisement
