Hitachi C 12LSH Handling Instructions Manual page 77

(1) Setting to cut crown moldings at positions 1
and 4 in Fig. 40 (see Fig. 41; tilt the motor
head to the left):
1 Turn the turntable to the right and set the
Miter Angle as follows:
* For 45° type crown moldings:
35.3° ( mark)
* For 38° type crown moldings:
31.6° ( mark)
2 Tilt the motor head to the left and set the
Bevel Angle as follows:
* For 45° type crown moldings:
30° ( mark)
* For 38° type crown moldings:
33.9° ( mark)
3 Position the crown molding so that the
upper surface (A in Fig. 39) contacts the
fence as indicated in Fig. 43.
(2) Setting to cut crown moldings at positions 2
and 3 in Fig. 40 (see Fig. 42; tilt the head to
the left):
1 Turn the turntable to the left and set the
Miter Angle as follows:
* For 45° type crown moldings:
35.3° ( mark)
* For 38° type crown moldings:
31.6° ( mark)
2 Tilt the head to the left and set the Bevel
Angle as follows:
* For 45° type crown moldings:
30° ( mark)
* For 38° type crown moldings:
33.9° ( mark)
3 Position the crown molding so that the
lower surface (B in Fig. 39) contacts the
fence as in Fig. 44.
1
Miter angle scale
Head
2
Fence (B)
Turntable
Fence
Ⓐ
Fence
Ⓑ
77
English
Head
Bevel angle scale
4
Fence (A)
Base
Turntable
Fig. 41
Bevel angle scale
3
Miter angle scale
Base
Fig. 42
Ⓑ
Table on base
Fig. 43
Ⓐ
Table on base
Fig. 44