Hitachi C 12LSH Handling Instructions Manual page 54

English
21. Do not use saw blades which are damaged or deformed.
22. Do not use saw blades manufactured from high speed steel.
23. Use only saw blades recommended by HITACHI.
24. The saw blades should be from 290 mm to 305 mm external diameter ranges.
25. Select the correct saw blade for the material to be cut.
26. Never operate the slide compound miter saw with the saw blade turned upward or
to the side.
27. Ensure that the workpiece is free of foreign matter such as nails.
28. Replace the table insert when worn.
29. Do not use the saw to cut other than aluminium, wood or similar materials.
30. Do not use the saw to cut other materials than those recommended by the
manufacturer.
31. Blade replacement procedure, including the method for repositioning and a
warning that this must be carried out correctly.
32. Connect the slide compound miter saw to a dust collecting device when sawing
wood.
33. Take care when slotting.
34. When transporting or carrying the tool, do not grasp the holder. Grasp the handle
instead of the holder.
35. Start cutting only after motor revolution reaches maximum speed.
36. Promptly cut OFF the switch when abnormality observed.
37. Shut off power and wait for saw blade to stop before servicing or adjusting tool.
38. During a miter or bevel cut the blade should not be lifted until it has stopped
rotation completely.
39. Take all the possibility of residual risks in cutting operation into your
consideration, such as the laser radiation to your eyes, the inadvertent access to
moving parts on slide mechanical parts on machine and so on.
40. Review this Manual and familiarize yourself with the safety rules and operating
instructions for this POWER TOOL before attempting to use it.
41. Always confi rm that the POWER TOOL is clean before using it.
42. Always wear snug-fi tting clothing, non-skid footwear (preferably with steel toes)
and eye protection when operating the POWER TOOL.
43. Always handle the POWER TOOL carefully. If the POWER TOOL falls or strikes
against a hard object, it might become deformed or cracked or sustain other
damage.
44. Always cease operating the saw at once, if you notice any abnormality whatsoever.
45. Always confi rm that all components are mounted properly and securely before
using the tool.
46. When replacing the saw blade, always confi rm that the rpm rating of the new blade
is correct for use on this tool.
47. Always shut off the power and wait for the saw blade to completely stop rotating
before undertaking any maintenance or adjustments.
48. During slide cutting, always push the saw blade away from the operator.
49. During miter or bevel cutting, always wait for the rotation of the blade to stop
completely before lifting the saw blade.
54