Hitachi C 12LSH Handling Instructions Manual page 69

13. Digital display panel (for C12LSH)
Miter angle window
(Displays arrows show angle
and direction that turntable is
rotating. Left is ← Right is →.)
Miter angle reset button
(1) Turning on the digital display switch
shows 0° for both miter and bevel angle,
regardless of main unit angle.
(2) Align the main unit angle with the tilt angle
(0°) and miter angle (0°) and hold down
their reset buttons for at least 0.2 seconds.
(3) Turning on the laser marker switch while
the digital display switch is on, lights up
the laser marker (On the C12RSH, only the
laser marker switch).
CAUTION
When operating the digital panel, have
the motor head section at the top limit position and the blade stopped.
NOTE
Before starting to cut, align the main unit to the miter angle 0° and the bevel angle 0° and
○
hold down the reset buttons for at least 0.2 seconds. If you press the digital display switch
to ON without aligning the main unit to 0°, then the fi gures appearing on the digital display
and the main unit angle will not match.
The laser marker will not light up if the digital display switch is turned off (only on C12LSH).
○
Do not use the main unit near equipment that generates electrical noise such as
○
generators. Electrical noise might cause faulty readings or operation on the digital display.
CAUTION
If the fi gure shown on the miter angle digital display is diff erent from the positive
stop angle (for example, 45.0° → 45.5°, 31.6° → 32.0°) then the positive stop has
probably deviated slightly from its correct position. If this happens, do as follows.
(1) Move the turntable left and right with the side handle loosened, and set the
turntable to the correct position.
Bevel angle window
(Displays arrows showing motor
head bevel angle and bevel
direction. Left is ← Right is →.)
Back light ON/OFF switch (Press
and the switch illuminates. Press
again and the lighting turns off .)
Fig. 23
Digital display switch
(for C12LSH)
(Also serves as laser
marker power switch.)
69
English
Bevel angle reset button
Laser marker switch
Fig. 24-a