YASKAWA PROFINET 1000 Series Technical Manual page 16

5 Installation Procedure
Wiring the Option
5.
Route the option wiring.
Depending on the drive model, some drives may require routing the wiring through the side of the front cover to
the outside to provide adequate space for the wiring. In these cases, using diagonal cutting pliers, cut out the
perforated openings on the left side of the drive front cover. Sharp edges along the cut out should be smoothed
down with a file or sand paper to prevent any damage to the wires.
5.a Route the PROFINET Cat 5e cable inside the enclosure for drives that do not require routing through the front
Table 5
cover. Refer to
2A0004 to 0040; 4A0002 to 0023; 5A0003 to 0011
2A0056 and above; 4A0031 and above; 5A0023 and above.
<1> Refer to Figure 7 for examples of the different wire routing techniques.
Figure 7
A – Route wires through the openings provided
on the left side of the front cover.
<1> The drive will not meet NEMA Type 1 requirements if wiring is exposed outside the enclosure.
6.
Connect the PROFINET Cat 5e communication cable to the option connector (CN1) port 1.
To connect the option to a network, firmly connect RJ45 8-pin Shielded Twisted Pair Cat 5e cable(s) into the
modular connector ports (see
Note: Do not connect or disconnect the communication cable while the drive is powered up or while the drive is in operation. Failure to
comply may cause a static discharge, which will cause the option card to stop working properly. Cycle power on the drive and
option card to reestablish functionality.
16
Figure 7
and to determine the proper wire routing by drive model.
Table 5 Model-Specific Cable Routing
Model CIMR-
A
<1>
Figure 7 Wire Routing Examples
Figure 7). Refer to
Through Front Cover
Figure 7
B – Use the open space provided inside the drive
to route option wiring.
Network Topology and Connections on page
YASKAWA SIEP YEACOM 07A 1000-Series Option PROFINET SI-EP3 Technical Manual
Wire Routing
<1>
Inside Drive
(A)
- Figure 7
B
17.
-
(B)