Omron NS Series Setup Manual page 36

2-2 Part Names and Functions
NS12/NS10 Rear Panel Switches
Main Circuit DC
Power Input Terminal Block Cover
Input Terminals
Covers the power input terminal block.
Used to connect
the power supply.
FG Terminal
Used to prevent
malfunctions due to
noise interference.
USB Host Connector
Used to connect to printers. It
is a USB Type A connector.
Note
2-8
USB Slave Connector
This is a USB Type B connector.
Refer to 3-3-2 Connecting via
USB.
Confirm system safety before turning the power ON/OFF or restarting. Otherwise the system
may operate unpredictably.
Expansion Interface Connector
Used to mount the Video Input
Unit or the Controller Link
Interface Unit.
Serial Port B Connector
Used to connect the host, CX-
Designer, and Bar Code Reader.
Uses an RS-232C 9-pin
connector.
Memory Card Connector
Used to connect the
memory card for storing
and transmitting screen
data, log data, and system
programs.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Reset Switch
Used to initialize the PT.
The status of screen data,
other registered data, and
the system menu, however,
will not change.
Battery Cover
The battery is installed
underneath the cover.
Serial Port A Connector
Used to connect the host, CX-Designer, and
Bar Code Reader. Uses an RS-232C 9-pin
connector.
Ethernet Connector
Used to connect the Ethernet cable.
Uses a 10Base-T/100Base-T 8-pin
modular plug.