Advertisement
Connecting the Hose to the Wiper
1. At the overhead console, route 1 end of the hose (3/16
inch) through the hole in the overhead console
20).
Figure 20
1. Hole (overhead console)
2. Bulb seal
3. Hose (3/16 inch)
2. Insert the small end of the barbed hose fitting into the
end of the hose from the wiper arm until the fitting
fully seats
(Figure
20).
3. Insert the large end of the barbed hose fitting to the
end of the hose (3/16 inch) until the fitting fully seats
(Figure
20).
Routing the Hose
1. Route the hose (3/16 inch) to the left of the overhead
console along the bulb seal at the front of the cab
frame
(Figure
21).
Figure 21
1. Hose (3/16 inch)
2. Hole (overhead console)
3. Bulb seal
2. Route the hose rearward along the left frame channel
of the cab
(Figure
21).
(Figure
4. Barbed hose fitting
5. Hose (wiper arm)
4. Pillar B (cab frame)
5. Front of the machine
3. Route the free end of the hose into the opening at the
top of the driver's side pillar B of the cab frame, and
down through the frame
Note: Use a stiff piece of wire, about 173 cm (68
inch) long, to pull (fish) the hose through pillar B of
the cab frame.
1. Hose (3/16 inch)
4. Route the free end of the hose across the back of the
cab, and align the hose with the barbed fitting in the
washer pump
(Figure
1. Front of the machine
2. Hose (3/16 inch)
8
(Figure
22).
Figure 22
2. Pillar B (cab frame)
23).
Figure 23
3. Barbed fitting (washer
pump)
Advertisement
