Advertisement
Figure 16
1. Holes-6.3 mm (1/4 inch)
4. Use an awl or punch to open a hole through the interior
foam panel
(Figure
17) at the hole locations that you
identified in step 3.
Note: Use caution when working with sharp awl or
punch.
Figure 17
1. Hole locations 6.3 mm (1/4
inch)-interior foam panel
5. Assemble the 2 carriage bolts (1/4 x 1-1/4 inches),
strap, and 2 spacers (1/4 inch) to the holes that you
made in the interior foam panel
2. Awl or punch
(Figure
18).
inches)
2. Strap
6. Assemble the tank-support bracket and washer-fluid
tank
(Figure
19) onto the 2 carriage bolts (1/4 x 1-1/4
inches) with the 2 flanged locknuts (1/4 inch).
1. Carriage bolt (1/4 x 1-1/4
inches)
7. Torque the flanged locknuts to 1,017 to 1,243 N∙cm
(90 to 110 in-lb).
7
Figure 18
4. Hole location 6.3 mm (1/4
inch)-interior foam panel
Figure 19
Advertisement
