Error Codes - Saeco 10002928 Operating And Maintenance Manual

GUIDE MESSAGE THAT APPEARS
out of service (xx)
restart to fix...
close coffee bean lid
fill container wth coffee
insert the brew group
insert grounds drawer
empty grounds
empty grounds drawer
close door
fill the water tank.
empty the drip tray
change filter
carafe missing
milk island missing
descale
stand-by...
energy saving...

ERROR CODES

HOW TO REMOVE THE MESSAGE
Where (xx) identifi es an error code.Turn off and after 30
seconds turn the machine on again to restore normal
operation.If the problem persists, call Saeco or an
authorized service centre and give the code (xx) shown on
the display.
Close the coffee bean lid to be able to make a beverage.
Put coffee beans into the bean hopper.
Insert the Brew Group in its place (see page 26).
Insert the coffee grounds drawer.
This preliminary warning does not stop the machine from
functioning. Proceed until the next message appears.
Remove the grounds drawer and dispose of the used coffee
grounds (see page 25, steps 1 and 2.).
Note: The grounds drawer must be emptied only when
the machine requires it and when the machine is turned
on. If you empty the drawer with the machine turned off
it will not reset the count of cycles.
In order for the machine to operate, the side service door
must be closed.
The tank must be removed and refi lled with fresh drinking
water.
Open the side service door and empty the drip tray located
under the Brew Group.
WARNING: WHENEVER THIS MESSAGE APPEARS, BE
SURE TO EMPTY THE COFFEE GROUNDS DRAWER AS
WELL.
The water fi lter must be replaced in the following cases:
1. 60 litres of water have been dispensed;
2. 60 days have passed since its installation;
3. 20 days have passed after the machine's last use.
Note: this message only appears when the fi lter alarm
function has been set to "on" (see page 19, menu 2.4).
The steam knob has been turned to the
either the Milk Island has not been installed or the carafe is
not positioned correctly. Install the Milk Island or position
the carafe correctly.
Otherwise, turn the knob until it is in the rest position ( ).
A descaling cycle must be performed on the machine's
internal circuits (see page 22).
Press the button.
27
position and