Error Codes - Saeco SM6682/10 Manual

7 Follow the instructions on the screen to start the descaling procedure. The descaling procedure lasts
approx. 30 minutes and consists of a descaling cycle and a rinsing cycle.
8 Once the descaling cycle is finished, you need to rinse the water tank and water circuit. Follow the
instructions on the screen.
9 Place a new AquaClean filter in the water tank and activate it (see 'Activating the AquaClean water filter
(5 min.)').
Tip: Using the AquaClean filter reduces the need for descaling!
What to do if the descaling procedure is interrupted
You can exit the descaling procedure by pressing the on/off icon on the control panel. If the descaling
procedure is interrupted before it is completely finished, some descaling liquid may remain in the water
tank or the water circuit. In that case, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine back
on. The machine will heat up and perform an automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first
dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding
ground coffee.
Note: If the descaling procedure was not completed, the machine will require another descaling procedure
as soon as possible.

Error codes

Below you find a list of the error codes showing problems that you can solve yourself. Video instructions are
available on www.saeco.com/care. If another error code appears, please contact the Consumer Care
Center in your country. For contact details, see the warranty leaflet.
Error Problem
code
01 The coffee funnel is
clogged.
03 The brew group is dirty
or not well-greased.
04 The brew group is not
positioned correctly.
05 There is air in the water
circuit.
Possible solution
Switch off the machine and unplug it. Remove the brew group.
Then open the lid of the pre-ground coffee compartment and
insert the spoon handle. Move the handle up and down until the
clogged ground coffee falls down. Visit www.saeco.com/care for
detailed video instructions.
Switch off the machine. Rinse the brew group with fresh water, let
it air-dry and then lubricate it (see 'Lubricating the brew group').
Consult chapter 'Cleaning the brew group' or visit
www.saeco.com/care for detailed video instructions. Then switch
the machine on again.
Switch off the machine. Remove the brew group and reinsert it.
Make sure that the brew group is in the correct position before
you insert it. Consult chapter 'Handling the brew group' or visit
www.saeco.com/care for detailed video instructions. Then switch
the machine on again.
Restart the machine by switching it off and on again. If this works,
dispense 2-3 cups of hot water. Descale the machine if you have
not done so for a longer period of time.
17
English