Toro Groundsmaster 360 Service Manual page 316

Testing the Traction Neutral Sensor (continued)
Electrical System: Testing the Electrical Components
C. Use a multimeter, check that the machine wire harness connector
terminal for black wire is closed (continuity) to the ground.
D. Turn key switch to the R
with a multimeter that the machine wire harness connector terminal for
pink wire has system voltage (12 VDC) present.
E. If the black wire is closed to the ground, the pink wire has system voltage
present, and the sensor LED did not function, replace the traction neutral
sensor. Adjust the sensor after installation; refer to
Neutral Sensor (page
9. After you complete the neutral sensor testing, ensure that the sensor
connector is plugged into machine wire harness.
10. Lower and secure the operator seat.
position (do not start the engine) and check
UN
5–44).
Page 5–80
Adjusting the Traction
Groundsmaster 360
16225SL Rev C