Philips VRX262AT Owner's Manual page 29

4
Use the Number buttons (1 - 8) to select a slot in which
to store the timer recording. There are eight timer recording
slots. Open slots will flash on-screen.
NOTE: If you enter a number for a slot that has already been used to
store a timer recording, PREVIOUSLY SET PROGRAM will appear on-
screen for a few seconds. Then information about the program in that
position will be displayed on-screen. If this happens, press the STA-
TUS/EXIT button twice. Then start again at step 1. (If you do not
press any buttons within 60 seconds, you will return to the previous
menu.)
5
Enter the channel you want to record.
If you have a basic antenna or cable hookup (as shown on
pages six-seven) enter the channel of the TV program you want
to record. (You must enter a 0 before all single digit channels.)
If you are recording from line input, press 0, 0. A/V IN will
appear on-screen.
If you are using a Cable Box, enter the Cable Box output chan-
nel (channel 03 or 04). See page eight for details.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
6
Enter the recording's start time.
Press two Number buttons for the hour you want the recording
to begin. Press two Number buttons for the minute(s) you want
the recording to begin. Press 1 for AM or 2 for PM. For example,
for 9:30 PM, press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON – – : – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
7
Enter the recording's stop time.
Follow the instructions in step 6 to set the recording's stop time
(AM or PM will be set automatically).
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON 09:30 PM
TIME OFF – – : – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
Instructions continue on page 30.
Timer Recording (cont'd) 29
4-7
2
1
5
4
8
7
0
PLAY
REW
STOP
Helpful Hint
• Entries that do not match the VCR's
internal clock or calendar will cause
a question mark to appear on-
screen.
3
6
9
+100
F.FWD