Operating Satellite Tuner - Philips VR1100/02X User Manual

O
PERATING
To use this remote control for operating the satellite tuner, you first need to set the manufacturer's code.
Note:
Though this remote control can operate
many manufacturers' satellite tuner, some
tuners may not operate or some functions
available on the tuners may not work with
this remote control.
1
Set Code
1 Press and hold SAT.
2 Press two Number buttons for the
manufacturer's code number of your
satellite tuner, referring to the table
to the right.
• For example, for 84, press 8 then
4.
3 Press STOP 7, then release SAT.
• The remote control can now operate
the satellite tuner of the selected code.
2
Confirm Setting
Press POWER, pointing the remote
control at the satellite tuner.
If the satellite tuner turns on or off,
your setting is completed.
If not, repeat steps above, using another
code.
After replacing the batteries
You need to reset the manufacturer's code
again.
S
ATELLITE
AMSTRAD.....................60, 61, 62
CANAL SATELLITE.................81
CANAL +...................................81
D-BOX........................................85
ECHOSTAR..........................78, 79
ECHOSTAR (VIA DIGITAL).....82
FINLUX......................................68
GRUNDIG...................................64
— 38 —
T
UNER
SATELLITE TUNER CODES
ITT ..............................................68
KATHREIN............................70,71
LUXOR.......................................68
NOKIA..................................68, 87
PACE................................................ 86
PHILIPS......................................66, 84
SALORA..........................................68
TPS...................................................83