Troubleshooting - DeWalt DWV901 Original Instructions Manual

DWV9316
DWV9500
The filter bags provide a clean, easy and quick
way to dispose of the dust collected.
Paper filter bags: The DWV9401 filter bags
are designed to capture many types of dust
including drywall, concrete and wood. These
bags should be disposed of once the airflow
becomes restricted. DO NOT reuse bags.
DWV9401
Fleece filter bag: The DWV9402 fleece bag
is designed to capture many types of dust
including drywall, concrete and wood. This
bag should be disposed of once the airflow
becomes restricted. DO NOT reuse this bag.
The fleece bag is ideal for heavier materials
such as concrete and drywall dust where a
paper filter bag may tear.
DWV9402
Plastic collection bag: The DWV9400
disposable plastic bag is designed to seal the
liner to the tank inlet without being pulled into
the filter during use. The plastic disposable
bag allows for easy cleanup and disposal of
dust and keeps dust from escaping back into
the atmosphere during emptying. Because
this bag is specially designed not to be pulled
into the filter, there will be a small amount of
dust remaining in the tank.
DWV9400
VAC RACK DWV9500 INSTALLATION (FIG. 10)
1. Remove the 4 carry handle screws using a T-25
star bit and remove the carry handle.
2. Install the vac rack reusing the carry handle
screws. Put them back in their original holes
and tighten.
3. Use the 2 screws (v) provided by placing them
in the rear holes of the vac rack. Push down
and turn each screw to break through the
15' Anti-Static
Accessory Hose
Vac Rack
Disposable paper
filter bag
Disposable fleece
filter bag
Disposable plastic
collection bag
material and into the hidden screw boss below.
Tighten.
CAUTION: Do not exceed 9 kg (20 lb)
in each 14 liter storage unit, maximum
2 storage units per dust extractor. Do
not exceed 18 kg (40 lb) in a 28 liter
storage unit, 1 storage unit per dust
extractor. Exceeding the recommended
height and/or weight could result in an
unstable dust extractor would could
cause injury or damage.
NOTICE: Do not remove dust extractor
head from tank with T-stack storage
units attached. Doing so could result in
damage to the dust extractor filters.
SECURING THE POWER CORD TO THE HOSE (FIG. 1)
The power cord (b) can be secured to the suction
hose (g) using the D279058CL hose clip (available
from your local D WALT supplier).
e
Consult your dealer for further information on the
appropriate accessories.

Troubleshooting

PROBLEm SOLUTION
Motor Check power cord, plugs and outlet.
does not
Ensure the on/off switch is in the ON
run
position ( ).
Ensure the tool control switch is in the
OFF position.
Suction Remove blockages in the suction
capacity nozzle, suction tube, suction hose
decreases or filters.
Replace the paper or fleece bag.
Check for proper installation of the
filters.
Clean or replace the filters.
Empty canister, refer to Empty
Canister under Operation.
English
9