Figure - QSC CXD Series Quick Start Manual

Bridged (A+B) and Separate (
For A+B (Bridged) to one loudspeaker load
Use one 2-wire cable; connect to:
• T1+/T3-
For & D (Separate) to two loudspeaker loads
Use two 2-wire cables; connect to:
• T5+/T6- for CH C
• T7+/T8- for CH D
A+B
8.0
1250
1250
Parallel hannels (AB D)
onnect the Loudspeakers
ARNINNNE: When the AC power is on, there may be potentially dangerous
voltage at the output terminals on the rear of the amplifier. Use caution to not
touch these contacts. Turn off the AC mains disconnect switch prior to making any
connections.
1. Turn off the AC mains power switch on the back of the amplifier.
2. Connect the loudspeaker wiring to the 8-pin Euro-style connector as needed for your amplifier's
configuration.

(Figure 6

through
you connect jumpers between the electrically same output terminals. Refer to
WARNING above the figure.
3. Install the female 8-pin Euro-style connector onto the male connector on the rear of the amplifier
as shown in Figure 9.
4. Use a Phillips screwdriver to secure the connector.
D ) hannels
C D A+B C+D
8.0 8.0 8.0 8.0
625 625 1250 1250
625 625 1250 1250
— Figure 7 —
— Figure 8 —
Figure 8) When combining channels, QSC recommends that
OUTPUTS TO SPEAKERS
+
CH A
-
+
CH B
-
+
CH C
-
+
CH D
-
Figure 9 and the
3
PARALLEL CHANNEL
COMBINING APPLICATIONS
CH AB
T1
+ -
T1 T2
+ -
T3 T4
T2
CH CD
+ -
T5 T6
T3
+ -
T7 T8
BRIDGED
T4
+
CH A B
CH ABC
+ -
T1 T3 + -
T2
T1
T5
+ -
T4
T3
+
CH C D -
+
T5 T6
T6 + -
T5 T7
CH ABCD
+
T7 CH AB CD
+ -
T1 T2
+ -
T1 T5
+ -
T3 T4
+ -
T8 T3 T7 + -
T5 T6
+ -
T7 T8
— Figure 9 —
TD-000350-00-E
EN