Using The Pxie-4309; Connecting Signals; Connecting Voltage Signals - National Instruments SC Express PXIe-4309 User Manual

Using the PXIe-4309

This chapter describes how to connect voltage signals to the PXIe-4309. It also provides the
I/O connector pin assignments of the module.
Driver support for the PXIe-4309 was first available in NI-DAQmx 17.1. For the list of devices
supported by a specific release, refer to the NI-DAQmx Readme, available on the
version-specific download page or installation media.

Connecting Signals

This section provides information regarding the connection of voltage signals.
Caution
shielded, twisted pair cables, and shielded accessories.
Caution
must be no longer than 3 m (10 ft.).
Caution
avoid injury, loss of data, or a system crash.

Connecting Voltage Signals

The TB-4309 (ST) or TB-4309 (MT) terminal block is available for
Note
measuring voltage signals.
To ensure the specified EMC performance, operate this product only with
To ensure the specified EMC performance, the length of all I/O cables
This icon denotes a caution, which advises you of precautions to take to
2
© National Instruments | 2-1