If You Cannot Make Clear Copies - Ricoh Aficio 1113 Operating Instructions Manual

Troubleshooting

If You Cannot Make Clear Copies

Problem
Copies appear dirty.
The reverse side of an original
image is copied.
3
A shadow appears on copies if
you use the pasted originals.
The same copy area is dirty
whenever making copies.
Copies are too light.
Parts of the image are not cop-
ied.
Copies are blank.
A moire pattern is produced
on copies.
R
When copying with the ADF,
black lines appear.
40
Causes
Image density is too dark.
Image density is too dark.
Image density is too dark.
The exposure glass, exposure
glass cover, or the ADF is
dirty.
Image density is too light.
Damp or rough grain paper is
used.
Toner bottle is almost empty.
The original is not placed cor-
rectly.
An improper paper size is se-
lected.
The original is not placed cor-
rectly.
Your original has a dot pat-
tern image or many lines.
Your ADF might be dirty.
Solutions
Adjust the image density. See
p.26 "Adjusting Copy Image
Density".
Adjust the image density. See
p.26 "Adjusting Copy Image
Density".
Adjust the image density. See
p.26 "Adjusting Copy Image
Density".
Change the orientation of the
original.
Put mending tape on the past-
ed part.
Clean them. See p.64 "Main-
taining Your Machine".
Adjust the image density. See
p.26 "Adjusting Copy Image
Density".
Use dry paper without rough
grain.
Add toner. See p.42 "D Add-
ing Toner".
Place originals correctly. See
p.22 "Placing Originals".
Select the proper paper size.
When using the exposure
glass, place the originals
down. When using the ADF,
place them face up. See p.22
"Placing Originals".
Place the original on the expo-
sure glass at a slight angle.
Clean the ADF with a cloth.
See p.64 "Maintaining Your
Machine".