Brother TD-4650TNWB User Manual page 70

Error Message
RFID TAG
FAILED
RFID ERROR
No Tag Found
Remove Label
or
No Paper
Note
If you cannot write RFID tags:
Make sure the media are smart labels that have RFID tags located in the correct position.

The RFID tag could be defective. Try another tag.

Set the label size correctly, and then calibrate the RFID tag.

Set the sensor sensitivity correctly (LCD: Sensor > Gap/Bline Ref Rate).

Check the data length size of the RFID commands.

Possible Cause
The tag cannot be
written.
The tag cannot be read.
The label is jammed
inside the machine or the
paper size is not correct.
 The label could be misaligned. Perform the
Sensor > Auto Calibration procedure to ensure
the label is at top-of-form.
 Select RFID > Control > Tag Calibration > RFID
Calibrate.
 Use smart labels with RFID tags located in the
correct position.
 The RFID tag could be defective. Try another tag.
 Make sure the application does not send too few
or too many digits to the RFID tag.
 Check that the RFID commands are correct.
 Make sure the media are smart labels with RFID
tags located in the correct position.
 The RFID tag could be defective. Try another tag.
 Remove the label carefully so as not to damage
the printer.
 Make sure the media are smart labels that have
RFID tags located in the correct position.
 To reduce vibration to the printer, position the
printer so printed labels can fall freely to a lower
surface.
 Calibrate the Gap/Black Mark Sensor.
 Set the label size correctly.
66
Solution