Mounting Guidelines - A.O. Smith CEWHR-PE6 User Manual

Mounting guidelines

Use a drill bit with diameter of 12 mm to drill 2 holes at least 100 mm deep in the wall.The two holes
should be aligned horizontally. The horizontal distance between the 2 holes is shown in the below
table(Fig. 3).
The distance A is 5~10mm(Fig. 4).The nylon expansion tubes should be inserted into the drill holes. It
is necessary to use a steel pipe to fastern the bolts into the nylon expansion tubes.The head of the screws
should be vertical upward. Place the water heater on wall mounting screws.Downwards on the heater
to ensure that the water heater is fixed steadily.
Fig. 3 Mounting distance of hangers
Caution:
Original installation accessories should be used on solid wall.
The heater may have has risk of fall in case of improper installation.
Fig. 4 Installation of mounting bracket
L
Right
Model
CEWHR-40PE6
CEWHR-50PE6
CEWHR-80PE6
CEWHR-100PE6
A
7
L(mm)
260
380 380
380
380
Wrong