Table of Contents
Advertisement
Stainless steel
Always use the mildest cleaning method first. Do not use steel wool to clean the product as
it will scratch the surface.
Burner grates
For durability and optimal performance, the side burner grates are crafted using porcelain
enamel over cast iron. It is recommended that the grates are cleaned while in place,
however if removing the grates take care as they are heavy and ensure they are placed on a
protected surface. Grates can be cleaned using hot soapy water.
Due to rapid temperature changes the porcelain may lift from the edges of the grates. If the
grates develop chips do not be concerned, over time the cast iron will darken to blend with the
enamel. When wiping areas where the enamel has lifted take care as the edges may be sharp.
Drip tray
To clean the drip tray, pull tray forward to remove. Wipe spills as soon as possible to
prevent them becoming baked on.
Cap
Port ring
Igniter
Base
Griddle
The griddle assembly should not be removed for cleaning.
After each use:
1 While the griddle is still hot, remove all food particles using a brass brush.
2 Wait for the griddle to cool to a medium heat before rubbing the surface
lightly with vegetable oil.
3 Remove the grease cup and wipe clean.
4 Wipe the griddle thoroughly to remove any residue or food particles.
To remove excess grease build up:
5 Apply 1 tablespoon of vinegar and ½ cup of water to the griddle plate.
6 Clean with a scouring cloth taking care not to scratch surface.
7 Re-season the griddle follow instructions on page 9.
The griddle will naturally darken over time, this is normal and does not require any
additional cleaning. To remove any heat discoloration a stainless steel cleaner can be used.
CARE AND CLEANING
Locating pins
Locating holes
Locating notch
Cleaning burner parts
1 Ensure all burner dials are in the
position and all surfaces are cool.
2 Remove the burner cap and port ring
and wash in hot soapy water, rinse and
dry. The burner ports can be cleaned
using a bristled brush if needed.
3 After cleaning, ensure the locating
pins are correctly aligned. Incorrect
alignment can cause poor burner
performance and dangerous flames.
OFF
17
Advertisement
Table of Contents
