Troubleshooting - Toro Flex-Force Power System 51827 Operator's Manual

Preparing the Battery Pack for Recycling
Important:
Upon removal, cover the terminals of the battery
pack with heavy-duty adhesive tape. Do not attempt to destroy or
disassemble the battery pack or remove any of its components.

Troubleshooting

Perform only the steps described in these instructions. All further
inspection, maintenance, and repair work must be performed by an
authorized service center or a similarly qualified specialist if you cannot
solve the problem yourself.
Always remove the battery from the tool when troubleshooting, inspecting,
maintaining, or cleaning the tool.
Problem
The tool does not start.
Lithium-ion battery packs labeled with the Call2Recycle seal
can be recycled at any participating retailer or battery recycling
facility in the Call2Recycle program (US and Canada only). To
locate a participating retailer or facility closest to you, please
call 1-800-822-8837 or visit www.call2recycle.org. If you
cannot locate a participating retailer or facility nearby, or if your
rechargeable battery is not labeled with the Call2Recycle seal,
please contact your local municipality for more information on
how to responsibly recycle the battery. If you are located outside
of the US and Canada, please contact your authorized Toro
distributor.
Possible Cause
1. The battery is not fully
installed in the tool.
2. The battery pack is not
charged.
3. The battery pack is
damaged.
4. There is another
electrical problem with
the tool.
23
Corrective Action
1. Remove and then
replace the battery into
the tool, making sure
that it is fully installed
and latched.
2. Remove the battery
pack from the tool and
charge it.
3. Replace the battery
pack.
4. Contact an Authorized
Service Dealer.