Ricoh Pro C7200 Operating Instructions Manual page 94

6. Image Quality Problem: Spots
Solution:
<If paper dust is stuck to the paper>
Clean the paper feed path (dust catcher, transfer timing roller, guide board, and paper feed roller)
between the paper tray in use and the transfer unit's nip (where the images are transferred from the
intermediate transfer belt to the paper). For details about cleaning the dust catcher, transfer timing
roller, guide board, and paper feed roller), see page 248 "Cleaning the Paper Feed Path".
(a) If the problem occurs on side 1
1. Which problem occurs?
Toner Blasting
White Spots
2. Is the value in 1214: [Paper Transfer Output] the one already configured and printed but
not resolved?
Yes
No
92
In [Advanced Settings] for the custom paper you are using, select 1214:
[Paper Transfer Output], and then increase the value in the following
corresponding settings by "2".
• [BW]
[Side 1]
• [FC/FCS]
[Side 1]
• [S]
[Side 1: Clear/Special], [Side 1: White]
In [Advanced Settings] for the custom paper you are using, select 1214:
[Paper Transfer Output], and then decrease the value in the following
corresponding settings by "2".
• [BW]
[Side 1]
• [FC/FCS]
[Side 1]
• [S]
[Side 1: Clear/Special], [Side 1: White]
Contact your service representative.
Go to the next step.