Filling Clean Water Tank - Vax Hard Floor Ultimate User Manual

S3S-U series UG - 15.08.13_User guide 29/08/2013 10:15 Page 5
Operation
Before you begin cleaning
IMPORTANT: Please refer to floor manufacturer's care recommendations before use and test the steam mop on a
discrete area of flooring to begin with.
IMPORTANT: Your detergent control dial will be set to 'tough stains' when you remove your steam mop from the box.
If you do not want to use detergent on your flooring, this must be rotated to 'steam/refreshes carpets only' position.
Always test on an inconspicuous area of flooring first before using detergent.

Filling clean water tank

IMPORTANT: Do not use hot or boiling water to fill clean water tank. Do not overfill the water tank.
WARNING: To reduce the risk of personal injury, unplug the stick steam mop when filling the unit.
Remove the clean
water/detergent tank
at the front of the unit.
Filling detergent tank
IMPORTANT: Do not mix Vax detergent with any other cleaning detergent.
This product can be used with and without detergent.
Remove the clean
water/detergent tank at
the front of the unit.
vax.co.uk
Twist the water cap
slightly anti-clockwise
to remove.
Twist the detergent cap
slightly anti-clockwise
to remove.
NOTE: Do
not over fill.
Fill the water tank with max
750ml of water and replace
the water cap. Tighten by
twisting clockwise.
NOTE: Do
not over fill.
Pour 50ml of Vax detergent
and 200ml of water into the
detergent tank and replace
the tank cap. Tighten by
twisting clockwise.*
Replace the tank, clicking into
place making sure the hard
water filter is in place. Do not
use steam mop without tanks
in place
Slide the water/detergent
tank down and snap into
place.
(*NOTE: 50ml detergent plus 200ml
water to 1 clean water tank).
5